When posting a claim, does PW factor in the "Individual maximum amount" when calculating the "Estimated payment"?
For example, if a patient has three D6010 procedures, and their insco covers 50%, with a UCR of $1775, and a Max of $1700 all of which are available, shouldn't the estimated payment be $1700? Math looks like this to me: $1775 x 50% = $887.50.; three of those means $887.50 x 3 = $2625.00; this amount exceeds $1700 so the estimated benefits would be $1700. However, PW says $2625.00 in the "Insurance Claim Information" screen.
Hello Dr. Dindo
Just to make sure, have you tried clicking on the "Re-estimate" button just under where it shows the estimation?
Sometimes the ledger/estimating doesn't update itself correctly and can show wrong until you manually click the button.
I did this set up in my own data and it calculated the 1700 correctly. Which is mainly what makes me curious about hitting the button to see if it'll calculate correctly. If not, we may need to get in and look at everything.
@joedindo - this has happened to our office more times than I care to count. I have expressed multiple times that there is no reason we should have to "re-estimate" every time to make sure that the software is giving us accurate information. Just fyi, we have found a few scenarios that are apt to give us this "greater than max" misinformation: 1) If there is a predetermination for the service that you have entered the approved amount for. Practice Works completely disregards what the patient has left in benefits and instead uses the figure that was entered on the predetermination. 2) If the patient changes plans or insurance companies. Practice Works will use the prior plan information until you click the "re-estimate" button as described previously.
When i tested the set up on mine where the patient had 1700 left in benefits, it did show that estimating would be at 1700
However, like @sonyap said, if the Tx plan had a pre-auth entered into it, it will pull from what was entered to be covered there and ignore remaining benefits under the assumption (which used to be more often true then not when this added to the software) that what the insurance company sent back as approved to be covered, already has them taking into consideration remaining benefits so it'll overrule what is shown in your data as remaining. so if they had 1700 left according to PracticeWorks, but the pre-auth says it covers 2300, it will show the 2300 being paid.
if the button is grayed out however, that typically would mean the claim was already cleared. It could also be because that patient was split from the original RP, so when you are trying to look at the information on the original RP's ledger, the estimating information isn't connected to it because the patient is no longer on that ledger. Just like after a split ledger, in order to resubmit claim, or post a payment on a claim from the patient that was split off, it will not allow it unless that patient is back on the ledger.
I'd want to take a look at it to be able to determine the actual reason though.